Piping module parameters


module 8 : Digitizing Plus
•	General Digitizing Plus Tools
•	Satin Parameters
•	Satin Serial Parameters
•	Fill(Step) Parameters
•	Zig-Zag Parameters
•	Piping Parameters
•	Running Parameters
•	Photo-stitch Parameters


Piping module™ parameters:


	Piping parameters for existing punching objects:

	With piping stitch type you can add a punching object of piping stitches. In this case, a smooth curve connects the nodes that you are adding. The program automatically adds the direction of stitches which connect a pair of nodes. The direction of the stitches can be edited independently of the node placements.
	The parameters that you can change in this type of punching are:
	Random length of stitches If Short/Long stitches should be made where needed.

	Random:
	With this parameter you can randomize the length of piping stitches, by specifying the percentage of stitch randomness in the selected or new punching object.

	Short/Long:
	This logical parameter has to do with the stitches that will pass from the thick or narrow parts of the created piping.
	If you want to keep the same density in all parts of piping you should enable this parameter. As a result there will be less stitches passing from the narrow parts of piping and more stitches from the thick parts. If this parameter is disabled, the same number of stitches will pass from all parts of piping. as a result, in some narrow parts, there may be too many stitches passing and the quality of the result may not be the expected one. On the other hand if this parameter is disabled, the piping gets a 3D look.

�